Skip to content

TSR for A4 B9

Module 17 - Dashboard - Security access 25327 Long Coding 2

  • Byte 05 - Activate Bit 2 "Traffic Sign Recognition" Long Coding 1 (tick if below did NOT get ticked while doing Long Coding 2) -traffic_sign_display_BAP (YES) -traffic_sign_detection (YES)

Module 5F - Multimedia - Security access 20103 Long Coding 2

  • Byte 24  Enable Bit 6 to make traffic signs appear
  • Byte 24  Enable Bit 7 for Predictive Route Data (Mandatory otherwise you'll get the error!)

Long Coding 1 (tick if below did NOT get ticked while doing Long Coding 2)

  • Byte_3_Country_Navigation (choose your region)
  • Byte_24_Navigation_System (activated)
  • Byte_24_VZA (activated)

Adaptation

  • Car_Function_Adaptations_Gen2
  • menu_display_road_sign_identification - Change value to "Activated"
  • menu_display_road_sign_identification_over_threshold - Change value to "Activated"
  • Car_Function_List_BAP_Gen2
  • traffic_sign_recognition_0x21 - Change value to "Activated"
  • traffic_sign_recognition_0x21_msg_bus - Change value to "Comfort data bus"

Module A5 - Driver Assistance - Security access 20103 Long coding 2

  • Byte 01 - Activate Bit 0 - Up to MY16 or
  • Byte 16 - Activate Bit 4 - From MY17

Adaptation

  • find in the menu ''function_module_road_sign_recognition'' change to 'activated'
  • find in the menu 'VZF_country_code' change to '0'
  • find in the menu 'VZE_show_administrative_speed_limits' change to 'show_always'
  • find in the menu 'VZE_show_valid_additional_signs' change to 'activated'
  • find in the menu 'VZE_prioritize_moisture' change to 'not activated'
  • find in the menu 'VZE_sorting_valid_signs' change to '174'
  • find in the menu 'CCP_interface' change to 'not activated'
  • find in the menu 'VZE_sorting_alternative_signs' change to '425' Set all 6 functions related to 'Dev_messages……' to 'not activated'
  • find in the menu 'mask_error_reactions_for_development' change to 'not activated' Set all 4 'masked_fault_classes' to '255'
  • find in the menu "road sign detection fusion mode" change the value to "road sign fusion"
  • find in the menu "display end of speed limit symbol" change the value to "active"
  • find in the menu "display no passing allowed" change the value to "active"
  • find in the menu 'predictive route data run time' change the value to "0 ms"
  • find in the menu "display valid additional signs" change the value to "100111"

If an error is stored in the Module 13, the following must be coded: Module 13 - Adaptive Cruise Control - Security access 20103 Long coding 2

  • Byte 01 - Activate Bit 0 "Traffic sign detection"